The Race — Building Democracy in the Age of AI. People race toward a shared finish line.
The Race
← Tools

Case study

Ratepayer Protection Act stalls after Senate cloture fails

What happened

On September 30, 2026, a US Senate vote to end debate on H.R.9340, the Ratepayer Protection Act, failed 57–43, short of the 60 votes required. The House had passed the proposal on September 16. The Senate vote did not enact the bill.

The proposal would require states or utilities to consider and determine standards for covered large electricity loads, including a 100-megawatt campus threshold. It would not immediately impose one uniform protective electricity rate throughout the country.

Why it matters

The proposal would use federal legislation to put large-load cost protections before state and utility decision makers. Its actual protection for other customers would depend on the standards and implementation. Failure to advance in the Senate means the proposed duties are not established law.

Supporting sources

  1. periodicalpress.senate.gov · Source 1 ↗
  2. govinfo.gov · Source 2 ↗